Wagner type 4.87mtr dia Radial Axial Ring Rolling Mill

Capable of rolling rings weighing over 45360.0 kgs (100000.0 lbs) Max ring outer diameter 4877.0 mm (192.0 inches) Min ring outer diameter 705.0 mm (27.7 inches) Max ring height w/pinch rolls 660.4 mm (26.0 inches) Max ring height w/o pinch rolls 1016.0 mm (40.0 inches) Radial mandrel stroke 914.4 mm (36.0 inches) Radial rolling mandrel diameter 266.7 mm (10.5 inches) Axial roll diameter 457.2 mm (18.0 inches) Axial Stroke 609.6 mm (24.0 inches) Axial rolls opening range: max 660.4 mm (26.0 inches) Axial rolls opening range: min 69.8 mm (2.7 inches) Nominal radial tonnage 231.4 mtons (255.0 stons) Nominal axial tonnage 145.2 mtons (160.0 stons) Main incoming AC voltage 4160.0 VAC Main motor power (king roll drive) 746.0 kW (1000.0 hp) • This mill will roll a 16 ft diameter ring (approximately 5 meters) • Oil Hydraulic Operating System • Complete with Operators Control Pulpit (new 1990s) • RexRoth Hydraulic System with six (6) Hydraulic Pumps • General Electric 1000hp King Roll drive at 650/1000 RPM (new 1990s) • General Electric 8000 LINE Adjustable Speed Drive Control Center (new 1990s) • 700 Volt DC Variable Speed Drive System (new 1990s) • (2) transformers – 500kVA and 1500kVA – both utilizing 4160 Volts AC • Radial Mandrel speed is 95 RPM and pressure is 2000 PSI • Axial Drive Speed range is 35 to 85 RPM • Cooling blowers for both the King Shaft and the Pinch Rolls • OverTemp sensors on the King Shaft and Pinch Roll Systems • Pinch roll carriage is equipped with four (4) guide rolls Very Good Working Condition and Still installed available for immediate inspection and delivery. 
 In the 1990s this Ring Mill was rebuilt with all new electrics & electronics at a cost of over $1.000.000 USD.