Kween B with NRM Bridge Down Stream Sheet Line

KWEEEN B WITH NRM BRIDGE DOWNSTREAM SHEET LINE: Sheet line consisting of: One used Kween B 120mm extruder 30:1 L:D vented open to atmosphere, Serial number 93053, Yr. of mfg. 2004, Motor AC Inverter type, 200 HP ( 150 Kw) TEFC type Inverter rated mfg. by Teco, controller Kaltec, temperature control panel with 6 barrel and 7 auxiliary zones, total 13, barrel electrically heated and air cooled by fans, all safety equipment installed, operating voltage 380-415 volt/3/50 One used Kween B hydraulic slide plate screen changer with 220 mm opening of screen area, includes hydraulic power pack, valves for screen change. One used Normag Model MSDP 240 melt pump with all controls, motor and gear reduction for drive with integrated pressure drive variation controls mounted in control panel for extruder drive motor. One used EDI die, model H75 with restrictor bar, S# 87-11177 built new in 1987 with periodic upgrades and rebuilds. Total width 44” (1070mm) includes deckles for width regulation, 5 heating zones on die, with all adapters and fittings to melt pump. Die cart included supporting die and melt pump. One used Bridge NRM sheet polish roll stack assembly, approximate year of mfg. around mid 80’s, upgraded periodically with new controls and consistent preventative maintenance. Roll width 1200mm ( 48”) x roll diameter of 300mm (12”) drive motors DC with Kaltec controls, pull rolls ( haul off rolls) Bridge NRM same mfg as above, DC drive motor with Kaltec controls, One used winder Bridge NRM with maximum width of 1200mm ( 48”) presently working on maximum 1100 mm ( 44”) with 3” air shaft diameter for cores. All equipment installed and in working order. Note: Kaltec is an industrial electronic manufacturer in Warrington Cheshire England and of excellent repute and manufacture of products and service. All electrics are rated for 380-415 volt, / 3 / 50 Price as is where is factory floor UK,